Feider Machines FRB900, Оригинальное руководство пользователя

Страница: 9 / 16

NOTE: Always change the blades at the same time, otherwise imbalance can cause
vibration and reduce the blades and tool life.
CAUTION!
Do not attempt to adjust the blade with cutter block screws, which are pre-set at
manufacturing.
Drive belt replacement
The drive belt is expendable. It is keeping abrasion during use.
The drive belt should be changed regularly.
CAUTION!
Replacing the drive belt should be done by authorized service only.
The machine should be used only with drive belt!
To replace the drive belt, please fellow below steps:
1. Take away the drive belt cover by remove the fixing screws.
2. Remove the damaged belt and use a soft brush to clean the pulleys and the surrounding
area.
3. With the three continuous “v” profiles on the inside, place the new belt over the bottom
pulley. Half fit the other end of the belt on the top pulley then roll the belt in place whilst
turning the pulley.
4. Check that the belt runs evenly by manually turning the belt and then re-assembly the
drive belt cover.
5. Carry out a test run before starting work to ensure that the tools are in good condition,
correctly mounted and able to turn freely. The trial run should be at last 60 sec
Clamping
screw
Blade
Blade ridge
09