ORIGINAL INSTRUCTIONS>EN
6
d.
Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the
accessory.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and
cause loss of control or kickback.
e.
Do not attach a saw chain woodcarving blade or toothed saw blade.
Such blades create
frequent kickback and loss of control.
1.4 Additional safety instructions for the concrete sander
Do not use the tool near explosive materials.
Do not work with materials containing asbestos.
Prior to every use, check the tool and its cable and plug. Have damages repaired only by specialists.
Insert the plug into the socket only when the tool is switched off.
Plug and switch the machine off if it is not under supervision, in case of putting up and stripping down the
machine, in case of voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. Like that you avoid that it starts suddenly.
Check the milling head before every use. Do not use damaged or sluggishly running milling stars.
Make sure that the tool was mounted properly, and let it run idly in a safe position for 30 seconds. Stop
the tool immediately if you found considerable vibrations or other defects.
Don't use the machine if a part of the housing is damaged or in case of damages on the switch, the cable
or plug.
Electrical tools have to be inspected visually by a specialist in regular intervals.
After interruption of your work, restart the tool only after having made sure that the milling head and the
milling stars are moving freely.
Do not touch rotating parts.
Persons under 16 years are not supposed to use the tool.
Keep the handles dry, clean and free of oil and grease.
Caution!
The milling head still runs for a little while after the machine is switched off.
When working with the machine, wear ear protectors, dust mask, goggles, safety gloves and sturdy work
clothes.
Always hold the machine with both hands.
Make sure that persons in the work space are not endangered by particles flying around.
In order to avoid the star holder and the milling stars getting damaged, work very carefully on edges or
corners.
Do not work on surfaces with steel reinforcements which lie open.
If the mains cable gets damaged or cut during the use, do not touch it. Switch off the tool and then pull
the plug out of the socket by using and extreme precaution. Never use the tool with a damaged mains
cable.
Symbols
In accordance with essential applicable safety standards of
European directives
WARNING-To reduce the risk of injury, user must read instruction
manual
Always wear goggles.
