Feider Machines FMP800-CL, Инструкция по эксплуатации, Страница: 7 / 16

5. ASSEMBLY
Before any work on the power tool itself, pull the mains plug.
Auxiliary handle
Operate your power tool only with the auxiliary handle.
Rotating the auxiliary handle
The auxiliary handle can be adjusted to any position in order to have a safe and fatigue-free working
position.
Loosen the lower part of the auxiliary handle and rotate the handle to the desired position. Then retighten
the lower part of the auxiliary handle.
Inserting SDS-plus drilling tools
The SDS-plus drill chuck allows easy and convenient changing of drilling tools without using additional tools.
Clean and lightly grease the shank end of the tool.
Insert the tool by turning it into the tool holder until it locks.
Check the lock by pulling the tool.
As a system requirement, the SDS-plus drill bit can move freely. This causes some radial runout when empty,
which does not affect hole accuracy because the bit self-centers while drilling.
Removing SDS-plus drilling tools
Push back the locking sleeve and remove the tool.
Adjusting the drilling depth
The required drilling depth can be set with the depth stop.
Insert the SDS-PLUS drill tool up to the stop in the SDS-plus tool holder. Otherwise, moving the SDS-plus
drilling tool can lead to incorrect setting of the drilling depth.
Loosen the lower part of the auxiliary handle and insert the depth stop into the auxiliary handle. Pull the
depth stop until the distance between the tip of the drill bit and the tip of the depth stop corresponds to the
desired drilling depth. Then tighten the handle.
Selecting drill chucks and Tools
For hammer drilling and chiseling, SDS-plus tolls are required that inserted in the SDS-plus drill chuck.
Note: Do not use tools without SDS-plus for hammer drilling or chiseling! Tools without SDS-plus and their
drill chucks are damaged by hammer drilling or chiseling.
Dust protection cap
The dust protection cap largely prevents the entry of drilling dust into the tool holder during operation. When
inserting the tool. Take care that the dust protection cap is not damaged.
A damaged dust protection cap should be changed immediately. We recommend having this carried
out by an after-sales service.
6. OPERATION
Switch on and off
Make sure the rotation switch is in its center position.
Connect the tool to the power supply.
Press the left or right rotation switch.
To start the machine, press the ON/Off switch.
To lock the ON/Off switch, it is best to turn it off and press the lock button again.
To switch off the machine, release the ON/Off button.
When the ON/OFF switch is locked, press it and then release it.
Place the switch in its center position to secure the ON/OFF switch.