9
-
Installation of the guard
Turn back the tool. Put the guard in the correct position (see above drawing). Screw it firmly and lock it with its
knob.
-
Installation of the disk
o
Place the inner flange on the spindle.
o
Place then the corresponding disk.
o
Place the outer flange the disk and screw it firmly with the pin wrench.
Following the disk, the outer flange can be installed on the two sides:
-
Installation of the auxiliary handle
The auxiliary handle can be installed in 3 positions: top of the tool and both sides of the tool. The place where
to install the auxiliary handle will depend of the position where you will use the tool. Screw firmly the handle
with the provided wrench until it locks in place. See the operation part for install the handle according the
position of tool.
4)
Operation
Before plug the tool, find the correct work position. You can turn the main handle position to 90º (left or right). To
change the position, push and hold the lock off button and turn the tool to desired position and lock it in place.
Then install the auxiliary handle (as explained above) according the position of the tool. Push and hold the same
lock off button to put the tool at its original position.
NOTE: always switch off the tool before change the position of the main handle and the auxiliary handle.
Plug the supply cord to a socket.
The ON/OFF switch has a safety switch which prevents inadvertent starting. To start the operation, push forward
the safety switch and push the ON/OFF switch. The safety switch and the ON/OFF switch must be hold together
during the operation.
To stop the operation, releases the switches button.
The tool will not operate if the safety switch is not pushed.
Rough grinding
For the best rough grinding results, hold the grinding wheel at an angle of between 30
o
and 40
o
to the work-piece
surface and guide back and forth over the work-piece in steady movements.
Cutting
When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane. The cutting wheel
must have a clean cutting edge. A diamond cutting wheel is best used to cut hard stone. It is prohibited to use the
machine on asbestos materials!
Never use a cutting wheel for rough grinding.
5)
Replace the disk
The tool must be completely switched off and unplugged before change the accessories.
Push and hold the spindle lock button. Use the pin wrench to unscrew the outer flange. Remove with your hands
the outer flange.
Remove the disk and install in place the other disk. Replace in place the outer flange and screw it firmly with the
pin wrench.
Содержание FM2030
Страница 12: ...12...
