6.8 INSTRUCTIONS FOR PERIODIC MAINTENANCE
To ensure long life, prevent damage and ensure the full functioning of the safety features the following
maintenance must be performed regularly. Guarantee claims can be recognized only if this work is
performed regularly and properly Failure to perform the prescribed maintenance work can lead to accidents!
Users of the tool must not perform any maintenance work not described in this Operator's manual. All such
work must be carried out by a service center.
General
Entire machine
Cutting disc
Clutch
Protection cover
Clean exterior check for damage. In case of damage, have repaired
by a qualified service center immediately Inspect regularly for
damage and wear.
Have inspected at a service center.
Clean
Before each
start
Cutting disc
Protective hood
Switch
Safety locking button
Throttle lever
Tank cap
Inspect for damage and make sure the cutting wheel is right for the
job
Adjust position
Functional check
Functional check
Functional check
Check for tightness
Every day
Idle speed
Check (cutting disc must not tum on idle)
Every week Starter housing
Starter cable
V-belt
Spark plug Muffler
Screws and nuts
Clean to ensure proper air cooling
Check for damage inspect for damage and wear
Check and replace if necessary
Check tightness of mounting
Check their condition and that they are firmly secured.
Monthly
Air filter insert
Check the air filter insert, clean as needed, replace alter 500
operating hours
Every 3
months
Suction head Fuel
Tank
Replace
Clean
Annually
Entire machine
Check at an authorized service center
Storage
Entire machine
Cutting disc
Fuel tank
Clean the exterior, check for damage. In case of damage, have
repaired by a qualified service center Immediately
Remove and clean
Empty and clean
18