unusual noise or vibration, shut off the power source and allow the machine to stop. Disconnect the
spark plug wire from the spark plug (electric unit disconnect from supply) and take the following
steps:
Inspect for damage;
Check for and tighten any loose parts ;
Have any damaged parts replaced or repaired with parts having equivalent specifications.
8) Do not allow processed material to build up in the discharge zone; this may prevent proper
discharge and can result in kickback of material through the feed intake opening;
9) If the machine becomes clogged at the inlet opening or discharge chute shut-off the power
source and disconnect the spark plug wire or remove the ignition key before clearing debris in the
inlet opening or discharge chute. Keep the power source clear of debris and other accumulations to
prevent damage to the power source or possible fire. Remember that operating the starting
mechanism on engine powered machines will still cause the cutting means to move;
10) keep all guards and deflectors in place and in good working condition;
11) Do not tamper with the power source governor settings; the governor controls the safe
maximum operating speed and protects the power source and all moving parts from damage
caused by over-speed. Seek authorized service if a problem exists;
12) Do not transport this machine while the power source is running;
13) Shut off the power source and disconnect the spark plug lead (electric unit disconnect from
supply) whenever you leave the work area;
14) Do not tilt the machine while the power source is running.
Maintenance and storage
a) When the machine is stopped for servicing, inspection, or storage, or to change an accessory,
shut off the power source, disconnect the spark plug wire from the spark plug (electric unit
disconnect from supply), make sure that all moving parts have come to a complete stop and, where
a key is fitted remove the key. Allow the machine to cool before making any inspections,
adjustments, etc.
b) Store the machine where fuel vapour will not reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Always allow the machine to cool before storing;
c) When servicing the cutting means be aware that, even though the power source will not start due
to the interlock feature of the guard, the cutting means can still be moved by a manual starting
mechanism.
Additional safety instructions for units with bagging attachments
a) Shut-off the power unit before attaching or removing the bag.
Symbols
Warning symbol.
Caution: Read carefully the manual before use.
04