10
3.2 Auto Searching:
Confirm that the transmitter has entered a normal working
condition.
Confirm that build in battery monitor has been fully charges or has
connected via DC power supply, long press “POWER” for 5s
～
8s, the
monitor will enter the working state.
Then press “
MODE
” and select “
RF1
” signal input. And press
“
AUTO1
”, “
RF1Searching ON
” will display on the bottom and middle
part of the screen, which means the monitor starts to auto searching,
when the screen on the upper left corner shows the
BAND: X CH: X
and image display at the same time, which means that receiving RF1
Channel has finished searching and detect the signals from
transmitters, now users can enter into RF2 channel auto searching.
Press “
MODE
” and select “
RF2
” signal input. And press “
AUTO2
”,
“
RF2 Searching ON
” will display on the bottom and middle of the
screen, which means the monitor starts to auto searching.
When the screen on the upper right corner shows the
BAND: X CH:
X
and image display at the same time, which means that receiving
RF2 Channel has finished searching and detect the signals from
transmitters.
