- 25 -
MAINTENANCE
Top Light Bulb Replacement, Fluorescent 12/1/19
1.
To remove bulb from top light housing, grip the bulb receptacle end caps at each end of bulb. Pull
the bulb receptacle end caps straight outward away from unit.
2.
The bulb is inside a clear shatterproof tube with a white plastic end cap on each end. Be careful not
to allow the bulb to slide out of the shatterproof tube.
3.
Reinstall new bulb in to the existing shatter proof tube and reuse white plastic end caps.
4.
Reinstall new bulb assembly in the same manner as described in the Bulb Removal Procedure. Be
sure bulb is secure in bulb receptacles.
Note: Be sure to use a direct equivalent to the original
bulb.
Shelf Light Bulb Replacement, Fluorescent 12/1/19
1.
All shelf light fixtures use a spring-loaded socket at one end. To remove the bulb, push the bulb
towards the spring-loaded socket until the opposite ends drops out of the socket.
2.
The bulb is inside a clear shatterproof tube with a black plastic cap on each end. Be careful not to
allow bulb to slide out of shatterproof tube.
3.
Reinstall new bulb in to the existing shatterproof tube and reuse black plastic end caps. Reinstall
bulb assembly in the same manner as described in the Bulb Removal Procedure. Be sure bulb is
secure in bulb receptacles.
Note: Be sure to use a direct equivalent to the original bulb.
Top/Ceiling Light Bulb Replacement, LED (Cases Manufactured after 12/01/19)
1.
Turn power switch on rear of case to “off.”
2.
Disconnect light cord barrel plug from receptacle in LED by pulling barrel plug straight out.
3.
The LED is attached to clips mounted to the ceiling or top light housing. Disengage the LED from
the clips.
4.
Attach the new LED to the clips on the ceiling. Be sure that the LED is centered about the clips.
Shelf Light Bulb Replacement, LED (Cases Manufactured after 12/01/19)
1.
Turn power switch on rear of case to “off.”
2.
Disconnect light cord barrel plug from receptacle in LED by pulling barrel plug straight out.
3.
The LED is adhered to the front shelf support with double-sided tape. It may be necessary to use a
razor blade to detach the LED from the top light housing. NOTE: TAKE CARE NOT TO
DAMAGE THE FINISH ON THE FRONT SHELF SUPPORT.
4.
Remove the remaining double-sided tape from the FRONT SHELF SUPPORT.
5.
Apply a new layer of double sided tape to the new LED and adhere to the front shelf support.
Locate new LED by centering between (2) .09 dia holes on the front shelf support.
