Federal ECGR50, Инструкция по установке и эксплуатации

Страница: 18 / 29

- 18 -
1. Remove all interior shelving as described in the shelving installation and removal section of this
manual.
2.
Remove both shelf standards from interior of case. First remove thumbscrew at bottom of shelf
standard and then slide shelf standard up to allow top key slot to clear.
Steps 3 & 4 on refrigerated only.
3.
Lift the display pan up and out of evaporator tub. Remove display pan through rear opening.
4.
Remove the evaporator fan shroud. First remove the thumbscrews along the backside of
evaporator fan shroud. Lift the rear of the evaporator fan shroud allowing the front to hinge on
fan shroud mounting tabs. Reach in and unplug the evaporator fan motor cord. Continue to lift
the evaporator fan shroud while at the same time pulling it to the door opening of case until the
slots in the evaporator fan shroud can clear the fan shroud mounting tabs. Remove evaporator
fan shroud through rear opening.
5.
Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a
damp cloth and allow todry.
NOTE: Depending on the amount of usage and spillage of foreign material, some fasteners may have to
be removed and parts disassembled to allow proper cleaning of the unit.
6.
Clean all shelves, shelf support bars, shelf light housings, shelf light housings, shelf brackets,
and display pans using warm soapy water and a brush. Rinse thoroughly and allow to dry.
7.
Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant such as PAM to make the doors operate smoother.
8.
Clean both sides of the doors and interior of the front glass using any common window cleaner.
NOTE: Front glass can be tilted forward to simplify front glass cleaning. See “Daily Cleaning” section
for glass tilting operation.
9.
Reassemble the case in reverse order starting with Step 6.
Exterior Cleaning
1.
Clean the front glass using any common window cleaner.
2.
The exterior surfaces should be wiped down using any ammoniated cleansers or warm soapy
water.
NOTE: For major spills or foreign material build-up use complete weekly cleaning instruction.