5
Installing the Light Heads
Installation and Service Instructions
Federal Signal
www.fedsig.com
Figure 2 XStream bracket-mounting
Visor
#8 Pan Head
Screw (2)
#10 Pan Head
Screw (2)
Lockwasher (2)
Bail
Bracket
Pivot
Bracket
Installing the Light Heads
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the
deployment path of an airbag. Failure to observe this warning will reduce the
effectiveness of the airbag or potentially dislodge the equipment, causing
serious injury or death.
LIGHT OUTPUT COMPLIANCE: This product is intended for supplemental
warning in conjunction with an approved primary warning light system.
Consult local codes and regulations to determine if the power supply/light
head combination complies with the horizontal or vertical mount position
required in your application. Failure to follow this warning could result in
reducing the light output and its effectiveness as a warning system.
LIGHT HAZARD: To be an effective warning device, this product produces
bright light that can be hazardous to your eyesight when viewed at a close
range. Do not stare directly into this lighting product at a close range, or
permanent damage to your eyesight may occur.
Before installing the lights, read all instructions and plan all wiring and cable
routing. To secure and protect the wiring, use grommets, wire ties, looms, and
cable mounts (installer-supplied) as needed.
