Vision SLR with the Hook-On Mounting Kit Manual
4
Hook-On Mounting Kit
Federal Signal
www.fedsig.com
Installing the Adjustable Foot Brackets
ROOF SUPPORT STRUCTURE: There is a roof support member that spans the distance between
the driver and passenger side. DO NOT DRILL THROUGH THIS MEMBER! Adjust any hole
locations until the holes can be drilled without going through this member. Failure to follow this
warning will weaken the roof of the vehicle and may lead to an increased chance of bodily injury
or death in a rollover accident.
ENSURE PROPER INSTALLATION OF MOUNTING FEET: Note that the LH Mounting Foot is for
the left side of the light bar, and the RH Mounting Foot is for the right side. Failure to follow this
precaution may damage the light bar.
DRILLING PRECAUTIONS: Before drilling holes, check the area into which you plan to drill to
ensure that you do not damage vehicle components. All drilled holes should be deburred and all
sharp edges should be smoothed. All wires going through drilled holes should be protected by
a grommet or convolute/split-loom tubing.
IMPORTANT
: Plan all cable routing before completing the installation. Plan the location of the wire
routing hole in the vehicle roof so that the power and communication cables do not have tight bends and
have some slack to allow disconnection on removal.
The adjustable foot brackets enable you mount the Vision SLR at the maximum height and to level the
light bar.
To install the brackets:
1.
To avoid marring the plastic domes, invert the light bar on soft rags or cardboard.
2.
Use the 5/16-18 pan Torx screws, 5/16-inch flat washers, and 5/16-inch lockwashers to install the
adjustable foot brackets on the mounting feet. See Figure 3.
