Permanent Mounting Kit for the Split Vision SLR
2
VSLR3, VSLR6, and VSLR8 Mounting Kits
Federal Signal
www.fedsig.com
Table 1 Mounting kit contents
One kit is supplied with VSLR3, and two kits with VSLR6 and VSLR8 models.
Qty. Description
Part Number
4
Screw, 1/4 x 3/4 inch, Type AB, HWH, SS BLK OX
7011183-12
8
Pad, Mounting, Rubber
8422A033
4
Nut, Hex, 3/8-16, HCR
7059124
4
Washer, 3/8, S.S
7072A035
4
Lockwasher, Split, 3/8 inch, S.S.
7074A046
1
Bracket, Mounting, LH
8652206-L
1
Bracket, Mounting, RH
8652206-R
Optional Brackets
Qty. Description
Part Number
1
Bracket, Short, Mounting, LH
865200957-L
1
Bracket, Short, Mounting, RH
865200957-R
Installing the Mounting Brackets on the Light Bar
To install the mounting brackets on the light bar:
1.
Carefully turn the light assembly upside down and place it on a surface that will not scratch the
domes.
2.
Assemble one LH and RH mounting bracket on the factory installed carriage bolts using 3/8-16 hex
nuts, 3/8-inch flat washers, and 3/8-inch split lockwashers as shown in Figures 1 and 2. Secure the
brackets in position; torque the nuts to 20 ft-lb.
Figure 1 RH bracket attached to passenger side of light bar
RH Mounting Bracket
Carriage Bolt (4)
(Supplied with Light Bar)
3/8-16 Hex Nut
3/8-inch Split Lockwasher
3/8-inch Washer
290A6847
3.
For the Model VSLR6 and VSLR8, repeat steps 1 and 2 on the other half of the light bar.
