16
Installation
Informer15 Speaker (Model IS-I-P15 Series C)
Federal Signal
www.fedsig.com
5
–
ISO-GND
6
–
Input #3
7
–
ISO-GND
8
–
Input #4
3.
The visual indicator is wired to JP3 for activation and powering.
4.
If controlling an external device, use JP6 to control an external relay to control the
device.
The Informer15 Speaker has one independently programmable open collector output
that can be used to control an external relay. The open collector/relay output timing is
configured and programmed into the Informer15 Speaker from the Commander
®
user
interface.
The open collector/relay output is capable of controlling an external device. The open
collector and +24 Vdc are located at pins 1 and 2 of the removable output connector
JP6 on the PC board.
The output for controlling an external relay is limited to 30 Vdc and 100 mA maximum.
The speaker provides a 24 Vdc source to power relays or devices that require current
a draw of less than 20 mA. If a relay is used, which requires up to 100 mA, an external
24 Vdc supply is required. Do not exceed the voltage and current ratings listed in the
Specifications section of this manual. When using this feature, the open collector/
relay outputs turn on until one of the following occurs:
• The programmed default timeout occurs
• The CANCEL or RESET command is received
You can configure the open collector/relay output to open, close, and cycle based on
a preprogrammed sequence. The open collector/relay output can also be configured
to turn on when PA VOIP is active. See the Programming section on page 17 to
learn how to set up, configure, program, and use Informer-IP devices.
5.
If using a scrolling message board, use JP11.
6.
If using in standalone mode (not connected to Ethernet network), install a shorting
jumper on JP8. See the following instructions.
Standalone mode allows the Informer15 Speaker to be activated from the Alarm
Initiation Inputs without being connected to a network. The Informer15 requires setup
before placing it into standalone mode. Perform all configurations before installing.
Once the unit is configured and tested, place a shorting jumper across pins 1 and 2
of JP8, OPTION 1. To configure the Informer15 Speaker, use Commander software
version 15.4 or later. See the Programming section on page 17 to learn how to set
up, configure, program, and use Informer-IP devices.
