Federal Signal Corporation CAMLCD-AHD-56, Инструкция по установке и эксплуатации, Страница: 25 / 68

21
Installing the Mobile Camera System
er/trigger wiring harness (CAMADP-INT-2) of the
CAMLCD-INT-56/CAMLCD-INT-70 monitor or
• one of the four camera inputs on the CAMBOX-
4NTSC/CAMBOX-4PAL control box (for use with the
CAMLCD-70 monitor) or
• one of the four camera inputs on the input/power/trigger wir-
ing harness (CAMADP-INT-4) of the CAMLCD-INT-70-B
or
b) a special DVR system camera-extension cable that is con-
nected to one of the four camera inputs on the CAMDVR-4-B
Mounting the Flush-Mount Camera
Option 1: Mounting the camera with the included bracket
1. Align the mounting bracket on the vehicle with the drilled mount-
ing holes, and then guide the camera output cable through the
camera barrel and nuts of the mounting bracket assembly (Figure
3 on page 20).
2. Guide the camera output cable into the 3/4 in (19.0 mm) hole and
secure the rubber grommet of the cable in the hole.
3. To affix the mounting bracket to the vehicle, choose the appropri -
ate screws for the holes you drilled:
• a) If you are using the self-tapping screws, guide each
screw through the camera mounting bracket, then into the
drilled holes. Fasten the screws tightly to the vehicle body.
• b) If you are using the machine screws, guide each screw
with its lock washer and flat washer through the camera’s
mounting bracket. Install the matching nut on the opposite
side of the vehicle surface. Fasten the mounting hardware
tightly to the vehicle body.
4. Install the camera and camera barrel, while adjusting the viewing
angle, in the mounting bracket with the included short screws
(with matching lock and flat washers).
5. Connect the camera to the monitor via a camera extension cable
(one CAMCABLE-SHORT/-5/-10/-15/-20/-40 or two connected
in series with CAMCABLE-EXT) or special DVR system cam-
era cable (as applicable). To obtain the correct image orienta-
tion, it may be necessary to rotate the camera in the barrel of