Function
Description
Takedown, Worklight
50W Halogen, GH‑8 (bi‑pin)
Part No. 8107169
Alley
35W Halogen MR11
Part No. 8107241
Reflector, 6 LED
6‑Button, S2 (Solaris)
Part No. 8653104
Reflector, 3 LED
Part No. 8583462
(Alley Position Option)
Multi‑channel
Part No. 2005382
circuit board
Table 1.
C.
Cleaning Reflector Assemblies.
Use a soft tissue to clean the reflectors. Avoid
heavy pressure and the use of caustic or petroleum base
solvents which will scratch or dull the surface.
D.
LED Panel Replacement.
A serious injury may result if the LED as-
sembly is touched when hot. Always allow the
LED assembly to cool before removing.
1. LED Reflector Replacement.
Individual LED reflectors may be replaced if
needed by disassembly of the LED reflector’s parent LED
Figure 5. LED Reflector Replacement.
-4-
panel from the lightbar. Removal of the dome above the
panel, followed by removal of the screws restraining the
panel and disconnection of the 9‑wire cable harness (see
figure 5) will allow access to the reflector’s cleaning or
replacement. Refer to table 1 for replacement part number.
NOTE
Individual LED Modules cannot be serviced. The
entire LED panel is replaced.
2. LED Panel Replacement.
In the rare occurrence a LED module is found
not functioning properly, the parent circuit board panel to
which it belongs needs to be replaced with its equivalent.
A corresponding label may be found on the topside of each
of the LED panels with a 2005xxxx‑xxxxxxxx pc board part
number and the finished model number (58300x‑xxxxx)
for ordering its replacement. See figures 4 and 5 for board
removal/replacement.
3. 15A Fuse Replacement.
Four 15A fuses are present on the main
control circuit board located on the passenger side of the
lightbar. Access the fuses by removing the sunscreen fold
from the top side of the panel to expose the control board
(see figures 2 and 7).
Figure 4. Alley MR11 Halogen Lamp Replacement.
290A5862
35W MR11 LAMP
DISCONNECT
ATTACHED
9-CONDUCTOR
CABLE
DISCONNECT
ATTACHED
GROUND STRAP
GROUND
STRAP
290A5863
LED REFLECTOR
(REMOVE REAR SCREW)
DISCONNECT ATTACHED
GROUND STRAP FROM
END PANEL
DISCONNECT ATTACHED
9-CONDUCTOR CABLE
FROM PANEL
GROUND
STRAP
