Fedders Trion, Установка, эксплуатация и обслуживание

Страница: 3 / 16

Cleaning Instructions
If the Air Purifier is in constant use, the Electronic Filter and
metal mesh Pre-filter require washing about once a month
to remove the particles collected from the air. If the unit
snaps frequently during operation, this is an indication that
the Electronic Filter needs to be cleaned.
Remove the Filter Assembly
Remove the Filter Access Cover by lifting upward. Lift the
Filter Assembly out of the cabinet using the handle on the
top of the filter.
The front filter is the metal mesh Pre-filter, the Electronic
Filter is the middle (large) filter, and the Charcoal Filter is in
the back of the Filter Assembly.
Wash the Pre-filter
Slide the metal mesh Pre-filter out of the filter rails located
on front side of the Filter Assembly.
Rinse thoroghly with warm water. Set aside to dry.
Wash the Electronic Filter
The Electronic Filter is designed so that it can be cleaned
using dishwashing detergent and hot water. Make a good
soaking solution in a tub or large basin, then completely
immerse the Electronic Filter and soak for 20 to 30 minutes
in the soaking solution.
After the Electronic Filter has soaked sufficiently, agitate
the cell up and down in the soaking solution until clean. If
the Electronic Filter is extremely dirty, spray it with a
common household cleaner or Electronic Air Cleaner
solution. Allow the filter to soak for five additional minutes
before proceeding with the rinse instructions.
Thoroughly rinse both sides of the Electronic Filter. If a
sprayer is available, spray with water. Check to make sure
each plate in the Electronic Filter is clean. Shake as much
water out of the Electronic Filter as possible. Allow the filter
to air dry a minimum of one hour before returning to
service.
Washing Tips
When handling the Electronic Filter, be careful not to
damage or distort wires or metal plates as this will cause
excessive snapping or arcing during operation.
Note: Slight discoloration of cell plates is normal after use
and does not affect the performance of the Electronic Air
Purifier.
3
CAUTION
UNPLUG UNIT FROM POWER SOURCE BEFORE CLEANING.
CAUTION
DO NOT WASH THE CHARCOAL FILTER.
Pre-filter:
Rinse with
warm water.
Electronic Filter:
Soak in soapy water
and rinse clean.
Charcoal Filter:
Do not wash
Electronic Air Purifier
E
N
G
L
I
S
H
Remove the Charcoal Filter
Lift the Charcoal Filter out of the filter rails located on the
rear side of the Filter Assembly.
Do not wash the charcoal filter. Washing the Charcoal Filter
will destroy its ability to absorb odor. However, lint and dirt
buildup can be removed with a vacuum cleaner using a
brush attachment.
Odor absorpton effectiveness will gradually deteriorate and
the Charcoal Filter should be replaced every three to four
months.
CAUTION
DO NOT CLEAN THE ELECTRONIC FILTER IN
DISHWASHER.