
FDI
NXP LPC3180 Demo
User’s Manual
FDI
Rev 2
Page 13
10/1/2007
Images may be downloaded to the LPC3180 Board’s SDRAM by double-clicking on the
“NXP Demo Setup” shortcut file or by entering the following commands manually into
the JLink Commander prompt window:
r
loadbin SIBL_208Mhz.bin, 0
setpc 0
g
h
s
s
s
s
speed 4000
// Switch the Thumb -> ARM
w2 0x0 0xa000
w2 0x2 0x4700
w4 0x4 0xeafffffe
setpc 0
g
h
loadbin u-boot.bin, 81EC0000
loadbin rootfs.ubt, 80020000
loadbin kernel.ubt, 80620000
loadbin uboot.ubt, 80800000
setpc 81EC0000
NOTE: The “NXP Demo Setup” shortcut ( ..\Software\Binaries\Programmed_Images)
expects JLink.exe to be located at "C:\Program
Files\SEGGER\JLinkARM_V356b\JLink.exe". If this is not the case on your system,
please modify the “NXP Demo Setup” shortcut.
NOTE: All .bin and .ubt files, except rootfs.ubt, should transfer to the LPC3180’s
SDRAM within a few minutes. The rootfs.ubt file may take up to 5 minutes to finish
downloading depending on its size.
To run u-boot for NAND flash programming, it is necessary to enter the following
commands into a J-Link Commander window. A new J-Link Commander window must
be opened if the above commands were not typed in manually.
setpc 81EC0000
g
After performing the above command, you will only have a few seconds to react and
enter U-Boot command prompt mode.
Содержание LPC3180
Страница 32: ...FDI NXP LPC3180 Demo User s Manual FDI Rev 2 Page 32 10 1 2007...
Страница 33: ......