ELI70-CR
User’s Manual
10/5/2016
Copyright ©2016,
Future Designs, Inc.
Revision 1.01
Page
7
of
11
Connections
Figure 3. ELI70-CR Connections
Power Details
A 12VDC +/- 5% power supply with a 2.0A output will power any board from the ELI Family. This
allows a common, off-the-shelf power supply such as the
T1071-P5P-ND
to be used for quick demos
or prototyping across the entire ELI Family. In general, any 12VDC power supply with a 2.1mm
center positive plug will be acceptable if it can provide enough current to power the particular ELI
unit being used. On the ELI70-CR plug power into the (P2) connector.
For volume production applications, the input power can be optimized for your particular ELI unit
and lower capacity power supplies can be used.
In cases where the barrel connector is not desired, you can use the alternate power input connector
(J8) with supports directly plugging in 20-26 AWG wire with maximum 5A current per contact. The
datasheet for this J8 connector (PCB terminal block - PTSM 0,5/ 2-2,5-H SMD WH R24 – 1814634)
can be found at
http://tinyurl.com/1814634
.
