ELI121-CRW
Quick Start Guide
Page
2
12/27/2016
Copyright ©2016, Future Designs, Inc.
Revision 1.02
3.
Getting Started with ELI121-CRW
A few notes prior to powering up your SBC:
•
BeagleBone Black (and many other SBCs) will boot up and drive ELI without any software changes.
•
Raspberry Pi requires a few additional steps which are listed in greater detail in the ELI Software Users
Manuals which can be found here:
http://www.teamfdi.com/wp-content/uploads/ELI-Software-Users-
•
For additional information for specific SBCs, see our ELI Software Users Manuals.
1.
Connect the HDMI cable from your SBC to the ELI board
2.
Connect the Mini USB to USB cable to your SBC and the ELI121-CR for touch input
(See Figure below)
3.
Apply Power to ELI with a 12VDC +/- 5% 2.0A power supply such as the Digi-key PN:
or
(See Figure below)
4.
Once you have verified or configured your SBC for the proper resolution, power on your SBC
5.
The ELI display will power on and show the output from the SBC
ELI121-CRW Connections
Power may be supplied either via the 2-pin terminal block J8 or via the 2.1mm power jack P2 (center positive)
For troubleshooting tips, please visit the FDI support website at:
http://www.teamfdi.com/support/
We’d like your feedback and welcome constructive comments to:
