ELECTRONICS
FCI Electronics
Manual Part No. 412905-000
Issued: 10/19/94
Page 4 of 9
Rev. 02/22/01 ECR V10315
Revision B
K\DCU\Manuals
OPERATION INSTRUCTIONS
1. With the hand tool securely held, insert the connector into the lower-jaw guide of the hand
tool. Using your fingers, index the connector into position for wire termination (Figure 2).
Figure 2
2.
Remove a section of the outer insulation jacket to expose the individual wires to a proper termination
length (see GS-20-004). It will not be necessary to strip the insulation from the individual wire
because the IDC section of the connector will make electrical contact with the wire causing
termination. If you have removed too much of the outer insulation it may be necessary to trim the
individual wires to length. Insert the individual wire into the slot in the top of the die along side the
position you wish to terminate. Keep pushing the wire into the slot until the wire bottoms out on the
tooling (Figure 3).
Figure 3
PDM: Rev:B Released
STATUS: Printed: Jan 14, 2004
