FCC BBQ Extreme 4.1, Инструкция по эксплуатации и техническому обслуживанию

Страница: 24 / 28

Lighting Instructions
!
IF BURNER FAILS TO IGNITE, TURN THE CONTROL KNOB AND THE CYLINDER
VALVE OFF (CLOCKWISE). WAIT FIVE MINUTES BEFORE ATTEMPTING TO
RELIGHT WITH IGNITION SEQUENCE. IF THE BBQ STILL WILL NOT LIGHT
USING NORMAL OR MANUAL LIGHTING, REFER TO THE TIPS SECTION IN THE
TROUBLESHOOTING MANUAL, OR CONTACT YOUR DEALER.
LIGHTING INSTRUCTIONS
1. Set all control knobs to off (red bar pointing upwards).
2.
Open the lid. The lid must always be open when lighting the grill.
3. Open the gas valve of the gas cylinder.
4. Push the knob of the desired burner in and turn it to the left. The
burner will ignite automatically.
5. Wait until the burner is lit, then the next burned may be lit with the
same procedure.
6.
Ignite the rest of the burners the same way as needed.
TIPS: Preheat the BBQ for about 10 minutes on maximum temperature.
After completion of preheating, turn all burners to the “LO“ position for
best cooking results.
If the burners do not ignite after 5 seconds, set all control knobs to off
(red bar pointing upwards) and close the gas valve of the gas cylinder. Wait
for 5 minutes. Repeat the above procedure.
MANUAL LIGHTING
If the electric ignitor of the appliance does not work or you like to light the
appliance manually using a match:
Do not lean over the appliance while lighting.
1. Set all control knobs to off (red bar pointing upwards).
2.
Open the lid.
3.
Open the gas valve of the gas cylinder.
4. Light a long match and enter it into the burner ports on the left or
right sidewall of the firebox.
5.
Push the control knob of the adjacent burner in, and turn it to the left.
6. Make sure the burner lights and stays lit.
7. Adjacent tube burners can be lighted by pushing their knobs in and
turning them to the left.
If the burners do not ignite after 5 seconds, set all control knobs to off
(red bar pointing upwards) and close the gas valve of the gas cylinder. Wait
for 5 minutes. Repeat the above procedure.
24