10/14
Ver 0.1
1.
From the IDLE mode, press [OK] → [OK] → [UP] buttons to enter [2.
Group Setting] menu.
2. The Wearable Pager will display current group number or 00 and wait for
user input.
3. To receive sensor information from all sensors set the Group ID of the
Wearable Pager to 00 by pressing [OK] twice.
4. This group ID will be transferred to Sensor Transmitter when they are
registered.
5.
If you want to set Wearable Pager’s group ID to 01 ~ 49, use [UP],
[DOWN] and [OK] to set Group ID.
6. You can go back to previous menu or previous position by holding down
the [OK] button for more than 3 seconds.
7. Once the Group ID is set up, the Wearable Pager will go back to IDLE
mode.
3.3 Personal Care
3.3.1 Fall Prevention (Wearable Pager + Bed Sensor Pad)
3.3.1.1 Setting up Bed Sensor Pad's Location Identifier Information
User can enter 4-digit number to identify Bed Sensor Pad location. For
example, upper 2-digit and lower 2-digit can be used to identify room
number and bed number respectively. This can be done while
registering the Sensor Transmitter as detailed below.
1. From IDLE Mode
of the Wearable Pager, Press [OK] → [OK] → [UP] →
[UP] → [OK] → [OK] buttons to enter Sensor Information setting menu.
2.
The display should show: [3. Registration] → [1. Pad].
3. The Wearable Pager will display 4-digit number from previous setting or
0000.
4. If you want to install Bed Sensor Pad to the 3rd bed in room 15, enter
1503.
5. Use [UP], [DOWN] and [OK] buttons to change and select the entered
numbers.
6. Now move to registration menu to register the selected Sensor
Transmitter to the Wearable Pager. Press the [OK] button to start
registration.
7. Wearable Pager will display will display [Registering] and will wait for the
registration request from the Sensor Transmitter
