Fbt MS02-CD3/DG, Инструкция по эксплуатации, Страница: 3 / 24

°When the unit is installed in a rack enclosure, the rack must have all the prerequisites required by the EN 60439-1 standard, in particular the
rear part must be closed by means of suitable panels.
INSTALLATION
GENERAL PRECAUTIONS
All FBT equipment is manufactured in accordance with the most stringent international safety standards and in compliance with European
Community requisites. In order to use the equipment correctly and effectively, it is important to be aware of all its characteristics by reading
these instructions and in particular the safety notes carefully. While the equipment is working, it is necessary to provide adequate
ventilation. The equipment must not be closed indide cabinets without ventilation or kept in the vicinity of sources of heat.
• Installation
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
WHERE MARKED, THIS SYMBOL INDICATES A DANGEROUS NON-ISOLATED
VOLTAGE INSIDE THE LOUDSPEAKER: SUCH VOLTAGE COULD BE
SUFFICIENT TO RESULT IN THE RISK OF ELECTRIC SHOCK
WHERE MARKED, THIS SYMBOL INDICATES IMPORTANT USAGE
AND MAINTENANCE INSTRUCTIONS IN THE ENCLOSED
DOCUMENTS. PLEASE REFER TO THE MANUAL
A U D I O C O N T R A C T O R
This equipment is designed for use with a mains voltage of 230Vac ±10% 50/60Hz. The ON/OFF switch controls the mains voltage. The
equipment is supplied with its own power supply cable, which is equipped with an earthing wire. The earth terminal of the mains plug
should never be removed under any circumstances. Connect the mains plug of the equipment to the power mains using the cable included
in the supply. Make sure that the power outlet is equipped with a connection to earth in accordance with the law. The power-supply circuit of
the equipment is protected by a fuse installed on the mains plug of the equipment.
• Power supply and earthing
Any activities inside the equipment such as maintenance and so on may only be carried out by specialised personnel: when the cover is
removed, parts liable to cause electric shocks are exposed. Before removing the cover always make sure that the power cord has been
disconnected. In the event that liquid is accidentally spilt onto the apparatus, disconnect the mains plug immediately and contact the
nearest Service Centre. The chassis connection may be used to connect other equipment only for the purpose of shielding the low signals:
this socket may not be used to connect the chassis to earth for safety purposes.
• Safety notes
1