ERROR INFORMATION
Err 1
The max. capacity value set up during the calibration is to low.
O-F
Overload: the weight is higher than the maximum capacity.
O-H
Keep the platform free during switching on. The 0 point of the calibration is too high.
O-L
The 0 point of the calibration is too low.
P-L
The battery
is down or in “low voltage” (put the battery in charge or replace the battery)
HOW TO SET THE SPECIFICATION
STEP
DISPLAY
DESCRIPTION
ACTION
SETTING
SWITCHING ON
1
Press the “ON/OFF”button, the display shows
the automatic setting of the scale (the digits
00000 ÷ 99999 appear)
When the setting is over press the buttons “F”
2
+ “Z/T” simultaneously. Now parameters
regulation starts.
X=0 : Constant switching on
X=1 : switching off in 2 minutes
X=2 : switching off in 4 minutes
AUTOMATIC SWITCHING OFF
Select
X=3 : switching off in 6 minutes
3
t X
Select the automatic time of switching off of the
X=4 : switching off in 8 minutes
X=5 : switching off in 10 minutes
scale
Confirm
X=6 : switching off in 12 minutes
X=7 : switching off in 14 minutes
X=8 : switching off in 16 minutes
X=9 : switching off in 18 minutes
4
CAL
Press the button “F” to return to the weighing
Weighing
mode.
WARNINGS
1.
Don’t disassemble the scale without following the necessary instructions. Don’t jump when standing on the load-bearing board to
avoid damaging the sensor inside.
2.
Don’t move the scale violently and abruptly. It is recommended to move and put down the scale gently.
3. In case of stains, it is suggested to wipe the stains with soft cloth soaked with detergent, and to dry it up with a soft clo
th. Don’t use
organic solutions and boiling water to wipe the stains, nor use water for cleaning.
4.
Keep the scale in a dry and neat environment. Don’t expose it outdoors, nor use it in locations near a fire, under direct sunshine or
with high temperature.
5. When lifting the height meter, it is suggested to pull straight along the pipe without exercising too much strength.
6.
The key “ON/OFF” on the screen board is meant only to switch off the screen power instead of the main power of the scale.
However, it is necessary to switch off the main power when the scale is not in use; otherwise the battery is most likely to get
damaged as a result of an over-discharge of electricity.
NINGBO YIFENG LIFECARE IMPORT AND EXPORT CO., LIMITED
Address:
18
TH
FLOOR,
HENGFU
BUILDING
1,
NO.
828
FUMING
ROAD,
NINGBO
,
CHINA
TEL:
0086-574-87482339
/
FAX:
8657487487171
MOB:
13736178445
/
：
13736178445
E-mail:
kype:
anncear
