Use of this Guitar Amplifier
To get the very best out of your Fazley Kubo 10 combo guitar amplifier, please follow the steps detailed
below.
Connecting Up
To connect your electric guitar with this amplifier, you will need a standard instrument or guitar cable. This is
usually a 6.35mm TS jackplug cable, with either straight or angled plugs. Unfortunately, this type of cable is
designed in such a way that it will always cause a minor short circuit when connected to the input of the
amplier. This usually causes behavior like crackling noises, but can also harm your instrument and amplifier.
Therefore it’s important to follow the following steps when connecting your instrument to this (or any other)
amplifier.
Make sure that the POWER switch of the amp is not activated, the LED indicating the power status should
be OFF.
Connect the instrument cable to your instrument.
Connect the cable to the guitar input of the amplifier.
Now switch on the power of the amp, the LED will light up.
If you wish to disconnect the instrument from your amplifier after use, follow the steps in reversed order:
Make sure that the power of the amp is disconnected, the LED indicating power should be OFF.
Remove the guitar cable plug from the amplifier.
Remove the guitar cable plug from your instrument.
Controls
Make sure that the controls are set to a normal level. Set the gain control and volume level to very low, and
the Treble and Bass tone controls to the middle, or 12 o’clock position. After the amplifier has been switched
on, these settings can be adjusted.
Set the Effect Controls at their minimum level.
Amp/Cab Sim
The Kubo 15BBT comes with various built-in amp/cab simulations, that when selected, emulate
characteristic sounds that can make your electric guitar sound entirely different.
The amp/cab simulations control section can be found on the left of the control panel. An amp/cab simulation
can be chosen using the Selection knob and the selection is indicated by an LED.
Amp/Cab Options:
- Metal Drive 2
- Metal Drive 1
- Overdrive 2
- Overdrive 1
- Crunch 2
- Crunch 1
- Clean
- Acoustic
Bluetooth
®
The amp/cab simulation control knob can also be pushed in and held to enable Bluetooth pairing with a
Bluetooth capable device.
Once the Bluetooth function has been enabled, it can be paired with a compatible device like a smartphone,
tablet, laptop, or computer.
Your device will find the Kubo 15BBT as ‘Kubo 15BBT’.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 08-06-2020 RV Revision date + author initials:
