Secure the machine on the transport vehicle against rolling, slip-
ping and turning over.
Loads must only be attached and hoisted by an expert / qualified
person.
Use only lifting and lashing tackle with sufficient load bearing
capacity for the weight to be loaded.
Fasten the lifting gear only at the specified lifting points.
Danger to the life of persons if they step or stand under a sus-
pended load.
When lifting the machine, avoid uncontrolled movements of the
load. If necessary, hold the load with guide ropes.
After the transport loosen the articulation lock again, as otherwise
the machine would not be steerable.
1.2.6 Start-up procedure
1.2.6.1 Prior to starting up
Use only machines which are serviced at regular intervals.
Become acquainted with the equipment, the indicators and control
elements, the working principle of the machine and the working
area.
Use your personal protective equipment (hard hat, safety boots, if
necessary also goggles and ear protection).
Do not take any loose objects with you or fasten them to the
machine.
Before mounting the machine check whether:
n
persons or obstructions are beside or under the machine,
n
the machine is free of oily and combustible materials,
n
all access steps, grips and platforms are free of obstacles,
grease, oils, fuel, dirt, snow and ice,
n
all safety elements are in place,
n
all maintenance flaps and doors are closed and locked.
Use only the intended access steps and grips to mount the
machine.
Before start up, carry out all required visual inspections and func-
tion tests.
If the following tests reveal damages or other faults, the machine
must not be operated, until these deficiencies have been corrected.
Do not operate the machine with defective indicators and control
elements.
1.2.6.2 Starting the engine
The machine must only be started and operated from the driver’s
seat.
General – Concerning your safety
BW 191 AD-5 AM / BW 206 AD-5 AM
25