Fayat Group BOMAG BMF 2500 M, Руководство по обслуживанию, Страница: 22 / 31

3.
On both travel pumps (4)
Ä
Fig. 10:
Loosen the counter nuts (2) half a turn on both high pressure
cartridges (1).
4. Screw in the screw (3) until a higher resistance can be felt.
Then screw the screw into the high pressure cartridge
another half turn.
5.
Tighten the counter nut.
ð
Tightening torque: 22 Nm!
6. The machine can now be towed.
7. After towing, re-establish the initial condition.
1.2.6 Maintenance and repair
1.2.6.1 Preliminary remarks and safety notes
DANGER!
Danger to life caused by an operationally
unsafe machine!
– The machine must only be serviced by quali-
fied and authorized personnel.
– Follow the safety regulations for maintenance
work.
WARNING!
Health hazard caused by fuels and lubricants!
– Safety regulations and environmental protec-
tion regulations must be followed when han-
dling fuels and lubricants
Ä
Chapter 1.2.4
„Handling fuels and lubricants“ on page 14 .
Wear your personal protective equipment.
Do not touch hot components.
Park the machine on horizontal, level, firm ground.
Perform maintenance work only with the engine shut down.
Make sure that the engine cannot be accidentally started during
maintenance work.
Thoroughly clean machine and engine before starting maintenance
work.
Before mounting the machine, check whether all access steps,
grips and platforms are free of obstacles, grease, oils, fuel, dirt,
snow and ice.
Opening the high pressure car-
tridges
S-940-0004
1 2
3
4
Fig. 10
General – Concerning your safety
BMF 2500 M 22