Rev 0.0
13
INSTALLATION INSTRUCTIONS
EN
5
INSTALLATION AND HOOK-UP
DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF ON THE
SHARP EDGES OF THE APPLIANCE.
Remove the polystyrene rack blocks. Position the appliance in the chosen instal-
lation position. The sides and rear of the appliance can lie against kitchen units or
walls. If the dishwasher is installed next to a heat source, separate it with a heat
insulating panel in order to prevent overheating and malfunctions. To assure sta-
bility, only install built-in appliances under continuous worktops, securing them
to the adjacent kitchen units or worktop with screws.
BUILDING-IN A DISHWASHER UNDERNEATH A CERAMIC HOB IS
ABSO-
LUTELY FORBIDDEN.
A DISHWASHER CAN BE BUILT-IN UNDERNEATH
A CONVENTIONAL HOB PROVIDED THERE IS
NO BREAK
IN THE KITCH-
EN WORKTOP, AND THE DISHWASHER AND HOB ARE
INSTALLED AND
SECURED CORRECTLY,
SO THAT
NO HAZARDS ARE GENERATED.
MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY INSTALLED
AND GROUNDED BY A QUALIFIED FITTER. THIS SAFETY REQUIRE-
MENT MUST BE MET. IN CASE OF DOUBT, CALL IN A QUALIFIED FIT-
TER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAIL-
URE TO GROUND THE APPLIANCE OR FROM A DEFECTIVE GROUND
CONNECTION .
BEFORE PROCEEDING WITH INSTALLATION, DISCONNECT THE
MAINS POWER SUPPLY FROM THE WORK AREA.
Only for free-standing models
It is strictly forbidden to mount a hob over a free-standing dishwasher.
•
If the appliance is not in a niche and can therefore be accessed on one side,
•
cover the door hinge area for safety reasons (cutting hazard). Covers are avail-
able as accessories from specialized retailers or from the Technical Service Cen-
tre.
To build in the dishwasher, purchase the
•
relative kit
from specialized retailers
or from the Technical Service Centre.
