1. Installation
_______________________________________________________________
10
1. Installation
Connect the receiver with the antenna cable and plug the receiver into your
TV set. Plug the power plugs of the connected devices in the power socket
and switch on the receiver with the Standby button.
Then press the
“MENU”
button
Now select the menu item “Installation” (PIN code: 0000). In this menu you can
edit your antenna settings and make additional settings to your satellite
reception
.
With the direction buttons
“CH
▲
”
and
“CH
▼
”
(up and down) as well as
„VOL
◄
“
and
“VOL
►
”
(jump from one level to the next) you can navigate the
menu, and with the
“OK”
button you can go into a menu item. To return to a
menu item, use the
“EXIT”
or
“MENU”
button
.
_____________________________________________________________________
The channels are preset. Adjust the settings only if you know the
exact values and are familiar with satellite transmission technology.
1.1 Antenna Settings
In this menu item you can set your receiver to the desired satellite. The following
parameters can be defined: LNB type, frequency, 22 kHz, DiSEqC, LNB power,
Scan mode. With the
„VOL
◄
“
and
“VOL
►
”
buttons you can enter the desired
values, then "Save" and confirm with the
“OK”
button
.
Satellite name
In the right column you can select among pre-programmed satellites the
satellites you receive. (Only the satellites which your satellite dish is aimed at are
receiveable.)
LNB Type
You can select the LNB type you use here (Standard: Universal).
22 kHz Tone
If your LNB is not universal, the value must be changed accordingly
.
