FAURE FBA6317, Руководство пользователя

Страница: 9 / 16

Problem Possible cause Solution
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate
of the refrigerator. During the automatic defrosting
process, frost defrosts on the rear
plate. This is correct.
Water flows into the refriger-
ator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water flows in-
to the water collector. Make sure that products do not touch
the rear plate.
Water flows on the ground.
The melting water outlet does not
flow in the evaporative tray above the
compressor. Attach the melting water outlet to the
evaporative tray.
The temperature in the appli-
ance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the appli-
ance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease
to room temperature before storage.
Many products are stored at the
same time. Store less products at the same time.
There is no cold air circulation in the
appliance. Make sure that there is cold air circu-
lation in the appliance.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power (the maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
9