FAURA NFC260 AQUA, Руководство пользователя

Страница: 120 / 134

13
Remote Controller Function
Introduction
Auto Speed
+
-
Humidify Timer
Sleep Lock
Plasma/Anion
Electrostatic
On/Off
Timer
Sleep
Lock
Plasma / Anion
Electrostatic
Humidify
+/-
When the unit is operating and this button
is pressed, the unit will automatically adjust
negative ion, electrostatic dust removal
device, switch of humidifying function and fan
speed according to sensed air quality and
ambient relative humidity.
Fan speed button will be invalid in this mode.
During operation, press this button and fan
speed will switch according to the sequence
below. LED lamp for fan speed will change
accordingly.
Silence
→
Low
→
Med.
→
High
When the unit operates at humidifying
mode, press button "+" or" –" to adjust set
humidity. When the unit is operating, in timer
setting mode, press button "+ "or "–" to
adjust time for turning off the unit. When the
unit is standby, in timer setting mode, press
button"+" or "–"to adjust time for turning on
the unit.
When the unit is operating and this button is
pressed, the unit will enter this mode. Press
this button again to cancel this mode.
When the unit is energized, press this
button to enter timer setting. Press + or – to
adjust time of timer and set range is 0~24
hours. Press this button again to cancel the
setting.
When the unit is operating, timer is set for
turning off the unit. If the unit is turned off,
timer is set for turning on the unit.
When the unit is operating and this button
is pressed, the unit will automatically adjust
negative ion, electrostatic dust removal
device and humidifying function based on
sensed air quality and ambient relative
humidity. Fan speed will switch between
silence and low speed.
Fan speed button will be invalid in this
mode.
When lock is off, press this button for over
2 seconds and relevant LED lamp will be
on. The controller will be locked. When lock
is on, press this button for over 2 seconds
again to cancel lock.Lock is off as default
once the unit is energized after power failure
occurs.
When the unit is operating, press this button
to turn on electrostatic mode. Press this
button again to quit this mode. (This button
is not available for model GCF220BKNA.)
Press this button in standby status and then
the unit will start operation. Press this button
again and the unit will stop operation.
↑
ON/OFF
Auto
Speed
Press this button and plasma and anion
will change as follows:
Plasma is off
Anion is on Plasma is on
Anion is off
Plasma is off
Anion is off