Fatigue Science ReadiBand, Руководство пользователя по оборудованию

Страница: 8 / 16

8
Using the ReadiBand
LED Status Indicators
The ReadiBand has four LEDs to notify users of the state of the
ReadiBand.
Top LED – Communicating with PC
Right LED – Low battery warning
Bottom LED – Communicating with charger
Left LED – Device Error
Wearing the ReadiBand
The ReadiBand should be worn on the wrist of
the non-dominant hand on the tightest setting
that feels comfortable. It should not cut off
circulation; if there is any discomfort, move to a
larger setting. If the device is too loose on the
smallest setting, use a sharp pair of scissors to cut
off the end of the strap with the marking on the
inside to be able to use the smallest settings. If
the device is too tight on the largest setting, use a
strap extender.
The ReadiBand is made of high-grade flexible plastic and is completely waterproof. The
device may be worn in the shower, bath, or while swimming. It should be taken off when
playing rough contact sports but otherwise should be worn at all times, including during light
exercise. If the ReadiBand pod is damaged, the entire ReadiBand should be replaced
immediately.
The ReadiBand can be used as a wrist watch to display the
current date and time. This is presented through a 5 x 19
pixel LED display on the top of the pod.
Cleaning the ReadiBand
During normal wear, clean the ReadiBand with soap and
warm water or an isopropyl alcohol wipe. If dirt and stains
do not come off, use a mild, non-abrasive cleaning pad or
cloth to remove any stains. Never submerge the ReadiBand
in alcohol or other solvents.
If excessive residue or dirt becomes trapped between the pod
and the band, the pod can be removed from the band. To
remove the pod from the ReadiBand, hold the pod in one
hand and push back against the band to strip off the band.
To place the pod back in the band, put the pod on the band
as shown at right and pull the band over the pod.