FATEK P5102S Скачать руководство пользователя страница 5

Страница: 5 / 8

4. Unpacking the Unit

FATEK HMI x1

Hook and Screw x7

FATEK PLC

Connector Rubber

Cover x1

A4 Double-sided Installation Guide x1

Power Connector x1

Pluggable Terminal

Block x1

5. Installation

Procedures

Push the HMI into the cutout until the

waterproof ring contacts the plate.

Insert a hook

into each mounting hole

on the HMI, and then tighten the

screws evenly

with a moderate torque.

Failure to tighten the screws may

cause the HMI to fall, malfunction

short-circuit. Excessive tightening may

cause deformation.

The necessary

torque

about 0.16N

Содержание P5102S

Страница 3: ...Switch HB1 PLC Screw Hole Power Connector COM3 COM4 Pluggable Terminal Block Ethernet RJ45 Connector for N N1 model Mini USB Connector USB Connector COM1 DB 9 Male Connector Micro SD Card Slot for N1 model Audio Phone Jack for N1 model W 271 5 mm H 213 5 mm D 44 6 mm 1 2 3 4 5 6 7 8 9 10 11 12 13 W H D 3 ...

Страница 5: ...nstallation Procedures z Push the HMI into the cutout until the waterproof ring contacts the plate z Insert a hook into each mounting hole on the HMI and then tighten the screws evenly with a moderate torque z Failure to tighten the screws may cause the HMI to fall malfunction or short circuit Excessive tightening may cause deformation The necessary torque is about 0 16N m 5 ...

Страница 7: ...S 232 1 NC 1 2 RX 3 TX 4 NC 5 GND 6 NC 7 RTS 8 CTS 9 NC 1 NC No Connection Pluggable Terminal Block PIN COM3 RS 422 COM3 RS 485 COM4 RS 485 1 NC NC DATA 2 NC NC DATA 3 ISO_GND ISO_GND ISO_GND 4 RX NC NC 5 RX NC NC 6 TX DATA NC 7 TX DATA NC 1 2 3 4 5 6 7 7 ...

Страница 8: ...and saving space using FATEK HB1 main units B1 extension modules is recommended z The rubber cover of the PLC connector can be taken off and placed into the termination switch slot 8 R Pobrano z https panele hmi pl panel hmi 10 2 p5102s fatek ...