Step 3
–
Get the horizontal pipe and insert the circular
part to the T-connector and tighten the knob, refer to
Figure 3
.
Step 1
–
Lay the black
plate down and loosen
the knob. Make sure to
loosen all the way and
insert the long chrome
pipe fully at the base
and tighten the knob
to secure (See
Figure
1
).
Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.FattoadPro.com/Videos
Step 2
–
Take the T-
connectors and insert in
the
chrome
pipe
and
tighten the knob to secure
in place as shown in
Figure
2
.
These
T-
connectors
should
be
facing
the
opposite
directions.
Step 4
–
Shown in
Figure 4
is how to place the support
arms. Take the support arms and slide the bolt in your
preferred hole and insert the screw to one of the holes of
the horizontal pipe. Place the knob at the bottom and
turn to tighten the arms in place. The knobs should be
pointing down. The width between the plates depends
on what size equipment you are using. You can adjust the
position of each side by loosening the appropriate swing
arm knob and moving the swing arm. Just be sure to
tighten the set screw knob before letting go. Also note
that placing these plates either too far forward or back
could cause an imbalance causing the stand to fall over
Step 5
–
Round
rubber
felts
are
placed
at
the
bottom of the black
plate and longer
ones are to be
placed
on
the
support
arms
to
keep
a
comfort
position for your
equipment.
Step 6
–
For safety reasons, please always make sure to
test the stability and safety of the product before use.
Double check all nuts and bolts, knobs and connectors,
make sure that these are tight and securely fastened
before use of your product. Test the product under light
use or light loads the first time to confirm assembly and
structure of the product is correct.
Tilt angle of the horizontal pipe can be adjusted to your
preference as well as the width capacity of the support
arms, depending on how you place the arms close or far to
each other.
Please note that hardware
bolts to assemble the stand
maybe screwed into the
parts themselves. So, for
example, if you are missing
a bolt that goes into the
bottom base support tube,
then look at the end of the bottom base support tube and
you will see that hardware bolt is already screwed into
the stand. All you need to do is unscrew that bolt and
then screw it back in to assemble the two parts that
connect on that end. If the stand is wobbly loosen up
each bolt on the stand slightly. Then tighten up 1 bolt all
the way as much as it will tighten. After that start on the
next bolt that is completely opposite of the 1st bolt that
you tightened. For example, if you first tightened up the
bolt in the top right of the stand, then next start to
tighten up the bolt on the bottom left. Keep going in
order of the opposite bolt that you tightened up last.
Once you are done, repeat the process of going through
and tightening up the bolts one more time.
