Fat Shark
5
RC Vision Systems
Head Tracker control:
Long Press: Activate/deactivate digital head tracking. Depressing display control button
(long press, vertical axis) toggles head tracker mode. On power up is normal (no zoom) and
the display will show entire camera image. On HT digital mode, the image will zoom in and
image will digitally pan and tilt in response to head motion.
Short Press: resets center reference position (both analog/digital).
Note analog head tracking output is always on.
RX power switch:
The receiver module power is controlled by this switch. If viewing video
source via the AV cable; the RX module needs to be turned off to avoid image conflict.
Channel select:
Pressing channel up/down buttons will cause the channel to incrementally
increase/decrease. Audio beep sounds on channel change. A long beep sounds on channel
top and bottom limits.
Note: Fat Shark only guarantees compatibility with Fat Shark or ImmersionRC transmitters.
CH1: 5740 MHz CH2: 5760 MHz CH3: 5780 MHz CH4: 5800 Mhz
CH5: 5820 MHz CH6: 5840 Mhz CH7: 5860 MHz
Low battery warning:
Audio warning if input voltage drops below 6.8V
Volume control:
each press of button increments volume up or down. Standard earphones
can be used with the Teleporter (not included).
Head Tracking Menu Navigation
To enter head tracking menu, hold head tracker button while inserting battery and
immediately release the button after barrel insertion. Note that reversing pan/tilt direction will
affect digital head tracking as well.
Beep code
Mode
1 short beep:
P/T on ch 5/6
2 short beep:
P/T on ch 6/7
3 short beep:
P/T on ch 7/8
4 short beep:
reverse pan direction
5 short beep:
Reverse tilt direction
1 long beep:
Adjust servo center point*
1 short beep:
Restore factory defaults
2 long beep:
no selection made, automatically exits menu
* Press HT button to gain manual control of the camera with the headset. Adjust camera to
desired center position by moving headset and press button to set new camera center. Note
that if your servos are not near the center point before adjusting, the servo travel may be
limited.
For a complete and up to date list of compatible RC radios and their setup, a head tracking
sticky thread is maintained at
www.FPVlab.com
under SPONSORS GATE/FAT SHARK
Operation notes:
Head tracker analog tracking is always on. It is not recommended to use analog and digital
head tracking simultaneously due to the doubling of motion (d analog).
