Fat Shark
6
RC Vision Systems
AV Cable Pinout
3.5mm AV Connector
: Yellow: Video,
White: Audio Left, Red: Audio Right
HDMI input
The HDMI port can be connected to HDMI devices via the HDMI mini port. Recommend to
first connect to the HDMI device then apply the power from the battery (allow the HDMI
device to initiate using power supplied through the cable by the host device before powering
goggles). Disconnect battery when switching between devices to clear the settings.
Note (1): Most HDMI connectivity issues are due to either incorrect monitor settings or faulty
HDMI cable. Before assuming the HDMI is defective, try with alternative HDMI sources and
alternative cables. HDMI cables may fracture over time at connector flex points.
Note (2): Receiver needs to be powered off in HDMI mode to prevent conflicting signals
being sent to the display.
Powering Options
If multiple power sources are supplied at same time (i.e. Futaba radio and head strap battery)
the headset will draw power from the highest voltage.
ezUHF TX/JR Module
ImmersionRC’s ezUHF transmitter and JR transmitter module can supply power (and head
tracking control) to the DominatorV3 goggle via a minDIN cable (included with the ezUHF).
Futaba Radio
The DominatorV3 can be powered off a Futaba radio via the Data Cable.
Note: Best to upgrade the Futaba radio to a 3S 2200mAh radio lipo pack for this type of
connection as the headset will cause extra drain on the transmitter battery pack. A normal
NiMh radio battery will not have sufficient battery life for safe flying.
Base Station
Use the AV cable to connect the video/audio.
AV cable has Y splitter with male and female DC head to share power with the external RX
supply (up to 13V). We do not recommend powering the goggles off RC packs without our
Safety Shield (see accessories) as RC packs have no current limiting circuitry to prevent fires
caused from shorts.
G r ound Vi deo AudR AuL
