Edition 1.0 pg4
2.2) T
he FT600W 7” color monitor
You will find a number of items in the packaging of the monitor.
-
Plastic bag with a wall mounting bracket .
-
Plastic bag with 2 plugs and screws for wall mounting and 2 x M4 bolt for mounting in a
different way.
-
11-pin connector with wires
-
7” white monitor
Place the wall mounting bracket against the wall and make sure that the UTP cable and any extra
cable are inside the bracket. Slide the monitor over the bracket.
The supplied extra connector has 4 extra wires.
-
Red-Black / can be used to power the monitor externally if the UTP cable is not going to be
used for that.
-
Black-Yellow / can be used to connect a bell push. When using this, the monitor will ring if an
extra bell push is placed somewhere.
-
All other connections have no application in this kit.
2.3) The FT600SW network switch
When you open the package you will find the following:
-
230 volt network cable
-
Fasttel 6 ports 10/100 poe switch
-
Bag with 2 wall mounting brackets incl. screws
The network switch has 4 POE connections of which you use 2.
Connection 3-4-5 are capped
Use connection 1 for the Doorphone Entry entrance station
Use conn
ection 2 for the FT600W 7” color monitor
Connect the connection marked with (6) to your internet router
Connect the 230 volt cable after you have properly installed the outdoor and indoor stations.
Both devices will receive an IP address from your router and will boot.
When both devices have started up, they are immediately ready for use.
You do not need to do anything further and your installation is ready for use.