35
• VIEW ANGLE SETUP
FLIP
: OFF,90
,100
,110
,120
,AUTO(18X,26X,36X MODEL) : ON,OFF(22X MODEL)
OFF:
the dome camera moves until 90
vertically.
90
, 100
, 110
, 120
:
allows the image to flip digitally when the camera moves over the
setting angle vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop.
At that time, release the
Joystick
handle instantly and pull it down again to run the auto-
flip function. When you use the panning range, we recommend using the flip mode to
AUTO.
TILT OVER ANGLE:
This option is used to set the limit of the horizontal view angle so that the trim ring or
ceiling does not obstruct the horizontal image when zooming out (wide angle).
ON:
In some installations it is desirable for the dome camera to be able to see above the
horizon. When this option is chosen, the dome will tilt up over the horizon (About -10
degrees). When the lens is zoomed out, you can see the ceiling line. But when the lens
is zoomed in, the viewing angle is narrower, and the ceiling line disappears.
Without Bubble:
The tilt range of the camera is limited to see the horizon so the picture
shows part of the ceiling line.
With Bubble:
The tilt range of the camera is limited to see below the horizon
(10 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin
Offset of tilt angle as described below.
VIEW ANGLE SETUP
PANNING RANGE
FLIP
: 90
TILT OVER ANGLE : ON
SAVE AND EXIT(ESC TO CANCEL)