Setting Up the Device
There is a quick set up video on the website in the support section.
1. Place the boards on the table tennis table as shown in the diagram for
training modes using the ball shooter, (see Figure 5). If you are setting
up for reaction mode then you will either need to remove the ball shooter
(or place the tiles at the other end of the table).
2. Make sure that the boards are pushed together so that they are firmly
connected together, in the correct order, (1,2,3,4), (see Figure 6). The
number of each board is printed next to the d-sub connector on the side of
the board. DO NOT attach the boards together or pull them apart when
the power is plugged in.
3. Attach the ball sensor to the robot ball shooter using the included Velcro,
(see Figure 7) The ball should pass in front of the sensor when it is ejected
from the shooter. This sensor should work with a large variety of ball
shooters.
4. Plug the other end of the ball sensor cable into the sensor socket in board
1.
5. Plug the power cord into the mains outlet and into the power input socket
in board 1. Be careful to ensure that the cords are not a tripping hazard
as you could risk injury as well as damaging the device.
6. If you are using the optional external display then plug it in and switch it
in
before
you switch on the main device.
7. With the power input, sensor cable (and optional external display if you
are using it) plugged in, you can switch the device on using the power
switch on board 1.
8. Connect to the device with the mobile app and begin your trainining
session.
7
