REBUILD/REPAIR INSTRUCTIONS
Page 5 of 9
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP172 Rev A 08/2/2021
12. Install collets and or jaws onto body.
•
Type 60 Connectors with threaded collets – The outside of the collets will
have a spiral groove denoting the installation sequence of the collets. Line
up the collets so that the spiral groove forms a constant line along/around
the circumference of the collets when they are assembled onto body. Install
each collet segment one by one by inserting them underneath the collet o-
ring. Make sure each collet segment is seated properly onto the body.
•
Type 70 Connectors with non-threaded jaws – No specific sequences are
required to align and install jaw segments. Install them onto the body one by
one by inserting them underneath the jaw o-ring. Make sure each jaw
segment is seated properly onto the body.
•
THE USE OF AN ADDITIONAL O-RING TO HOLD THE
COLLETS/JAWS IN PLACE WILL HELP AS EACH SEGMENT IS
LOADED. THEN REMOVE THE O-RING FROM CONNECTOR.
13. Allow collets/jaws to open enough to install spring and piston into body.
14. IN SOME CASES THE SPRING AND PISTON MIGHT NEED TO BE
INSTALLED AND PRESSED DOWN BEFORE COLLETS/JAWS ARE
INSTALLED AROUND THE BODY. MAKE SURE
NOT TO DAMAGE MAIN SEAL INSIDE PISTON.
SPIRAL
GROOVES
