2557
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax +48 58 56 300 80
15
In the event of damage to the electric device must be replaced for new.
Replacing the power cable can be performed only by authorized electrician.
Do not solder the components that are energized!
After work, you should put down the tool on the stand and allow to cool soldering iron. It is
only acceptable way of cooling the tool. Do not quench the soldering iron by inserting into
water, it can cause electric shock.
The device can be used by children over 8 years of age and persons with reduced physical,
sensory and mental or by a person without experience and knowledge if they remained
under the supervision or have been transferred to them instructions for safe use and
information about existing risks.
Cleaning and maintenance should not be made by children without supervision.
Preparing to work
Before starting work, check that the housing body and the cable with plug and external
extension cables are not damaged. In case necessary tool to clean from dirt and patency
vents.
In the case of damage it is prohibited from further work!
Warning! All activities related to the replacement of the mainsail, light bulbs, etc. Should be
carried out during power off tool, so before these steps: Pull the plug of the tool from the
mains socket!
Before using the tool, make sure that the parameters of the mains are compatible with the
data on the nameplate.
Before welding should be cleaned thoroughly combined metal components, as well as
caves soldering iron. In the case of burnout grotto replace it with a new one.
Using the tools
Soldering should be done by an adult familiar with safety regulations and hygiene at work
related to soldering.
Warning! The tool is not designed for continuous operation! The maximum working time is
12 seconds, then you should stop work at least 48 seconds.
Maintenance and inspection
WARNING! Before adjustment, servicing or maintenance pull plug tools from a wall outlet.
After the operation check technical condition of power by visual inspection and assessment:
body and handles, electric cable with plug and the fairlead, the action switch electrical
patency ventilation slots, sparking brushes, noise level bearings and gear, starting and
Содержание 2557
Страница 2: ......