12
3.
Place the tool with the saw blade (3) lightly
touching the surface
cutting teeth NOT touching the surface to
be cut.
4.
Set the speed to the fastest
(Fig. 7 on Page 11).
5.
Turn the tool ON (Fig. 6 on Pages 10
11).
6.
When the tool reaches its maximum set
speed, carefully plunge the blade into the
door jamb while sliding the blade along
floor tile.
NOTE:
Hold the tool tightly and do not put too
much forward pressure on the sa
cutting, as this will cause the tool to vibrate
excessively.
2
FLUSH CUTTING A DOOR JAMB AND
CASING FOR INSTALLING FLOORING
The oscillating tool can be used to flush cut a
door jamb and casing to allow space for the new
flooring to fit neatly under the door jamb and
casing. For the purpose of demonstrating the
procedure, floor tile is being used.
1.
Install the end cutting saw blade for wood
in the tool (Fig. 1 & 2 on Pages 9 & 10).
NOTE:
The blade should be centered on the
tool housing and NOT installed in the 90°
position.
2.
Place a scrap piece of floor tile (1) on the
floor about 1/2" (12.5 mm) from the door
jamb (2) (Fig. 8).
NOTE:
Make sure the “good” side of the tile is
facing upward to provide a smooth surface for
the blade to follow.
4
3
Fig. 8
7.
Continue to make several plunge cuts
until the bottom of the
casing are completely
loose pieces (4) can be easily
Follow the same basic procedure for installing
carpet, using a thicker spacer that is the same
thickness of the carpet being installed.
ASSEMBLY AND OPERATING
For safety reasons, the operator must read
the sections of this Owner’s manual
entitled “GENERAL SAFETY WARNINGS”,
“POWER TOOL SAFETY”, “SPECIFIC
SAFETY
RULES” and “SYMBOLS” before using this
oscillating tool.
Verify the following every time the
oscillating tool is used:
1.
Safety glasses, safety goggles, or
face shield are being worn.
2.
Hearing protection is being worn.
3.
The blade or sandpaper is in
good condition.
4.
The accessory is properly tightened
onto the accessory holder of the tool.
Failure to observe these safety rules will
significantly increase the risk of injury.
!
WARNING
Place the tool with the saw blade (3) lightly
touching the surface of the tile and the
cutting teeth NOT touching the surface to
Set the speed to the fastest speed
11).
the tool ON (Fig. 6 on Pages 10 &
When the tool reaches its maximum set
speed, carefully plunge the blade into the
door jamb while sliding the blade along the
Hold the tool tightly and do not put too
much forward pressure on the saw blade when
cutting, as this will cause the tool to vibrate
1
Fig. 8
Continue to make several plunge cuts
the door jamb and
are completely cut off and the
(4) can be easily removed.
Follow the same basic procedure for installing
using a thicker spacer that is the same
thickness of the carpet being installed.
OPERATING
Содержание 86225-1
Страница 8: ...8 SAVE THESE INSTRUCTIONS FOR REFERENCE...
