Fast DP9D, Руководство пользователя

Страница: 54 / 75

TRANSPORTING
TRANSPORTING Dry DuraPlacer 9 / 13 / 14 Ton - 40' / 60' Page 38
E. Gauge
F. Knob
G. Lock Ring
H. Down Pressure Valve for Main Wings
I. Down Pressure Valve for Flip Wings
(if equipped)
Unfolding/Extending the Toolbar
(continued)
7. Move latch switch (B) to engage the
hitch latch.
8. Move flip wing switch (C) to Field
Position and hold to unfold flip wings.
9. SCV II may now be disengaged and
returned to the neutral position until a
wing folding function is required.
10. Check the amount of down pressure
to inner wings by lowering the row
units to the ground while sitting still
and setting SCV I to continuous
down.
a. Hydraulic down pressure
gauge (E) should read
between 700 and 1000 psi but
see Step 11 below.
b. Down pressure may be
adjusted by turning knob (F)
on down pressure valve (H)
but see Step 11 below.
11. Use only as much down pressure as
needed to maintain a level toolbar
and consistent coulter or disc
penetration depth across the entire
toolbar. Excess pressure could cause
damage to the toolbar.
a. Turn knob clockwise to
increase pressure and
counterclockwise to decrease
down pressure.
b. To change pressure, loosen
lock ring (G) and turn
adjustment knob a 1/4 turn at
a time.
c. Do not exceed 1500 PSI.
12. Pull SCV I backward to fully raise
toolbar and kick wings up.
13. Toolbar is now ready for field
application.