Fast DP18L, Руководство пользователя

Страница: 35 / 81

PREPARING THE MACHINE Liquid DuraPlacer DP18L / DP24L Page 19
PREPARING THE MACHINE
Use the Tractor Operator’s Manual
Always refer to tractor operator's manual for specific detailed information regarding operation of
equipment.
Pre-Operation Checklist
Efficient and safe operation of the machine requires that each Operator reads and understands
operating procedures and all related safety precautions outlined in this section. A pre-operational
checklist is provided for the Operator. It is important for both personal safety and maintaining the
good mechanical condition of the DuraPlacer that this checklist be followed.
Before operating the DuraPlacer, check the following items:
1. Lubricate machine per the schedule outlined in the LUBRICATION and
MAINTENANCE section.
2. Use only a tractor of adequate power and weight to operate the DuraPlacer. See the
SPECIFICATIONS section for recommendations.
3. Be sure that the machine is properly attached to the tractor. Be sure that a mechanical
retainer is installed through the drawbar and that a pin and safety chain are installed.
4. Inspect all hydraulic lines, hoses, fittings, and couplers for tightness. See Tightening
Hardware for break-in period recommendations.
5. IMPORTANT : Extend the axles out of the shipping width setting and set the track or
tire width for your application. The unit is shipped with axles to the narrowest setting
using the shipping holes for shipping purposes only. See
SETTING AXLE WIDTH .
6. Check tires and verify they are inflated to the specified pressure. See Checking Tire
Pressure
7. Check track tension and hardware torque.
8. Calibrate the DuraPlacer if at the start of the season or a new applicator rate is being
used.
9. Check the condition and routing of all fluid hoses and lines. Be sure that all lines are
routed in large arcs. Replace any that are damaged. Re-route those that are rubbed,
pinched, or crimped. See
Replace Hydraulic Hoses .
10. Check placement components. Remove and replace any that are worn.
11. Remove all entangled material. Raise the toolbar and turn the metering pump slightly.
Check that there is liquid coming out at each application site. Unplug or connect lines
as required. Replace any plugged nozzles or tubes.