FMT18-2
Parts & Instructions
Fast Mover Tools Ltd
T: 01582 661993 F: 01582 667100 E: [email protected]
W: www.fastmovertoolsuk.com
4
- Ensure that cables are always protected against short circuit and overload.
- Regularly inspect power supply cables and plugs for wear or damage and check all connections
to ensure that none is loose or damaged.
- Ensure that the voltage rating of the compressor matches your power supply and that the plug is
fitted with the correct fuse.
- Do not yank the plug from the socket as can cause damage to both plug and socket.
Any
damage to plugs or sockets is potentially lethal
.
- Never carry any electrical tool by it’s power lead.
- If you are using an extension reel, ensure that it is fully unwound and that an RCD is fitted. A
minimum cable core of 1.5mm
2
is recommended although a core of 2.5mm
2
will ensure that heavy
loads can be handled. Your extension reel needs to be marked for outdoor use if working outside.
- When the ASTA/BS approved UK 3 pin plug is damaged, cut the cable close to the plug and
dispose of the it safely. Fit a new plug according to the following instructions;
1: Connect the GREEN/YELLOW earth wire to the earth terminal
‘E’.
2: Connect the BROWN live wire to the live terminal ‘L’.
3: Connect the BLUE neutral wire to the neutral terminal ‘N’.
4: After wiring, check that there are no bare wires, that all wires
have been correctly connected, that the cable outer insulation
extends beyond the cable restraint and that the restraint is tight.
The plug fitted to this compressor is fitted with a 13amp fuse.
Double insulated products, which are always marked with this symbol are fitted with live
(brown) and neutral (blue) wires only. To rewire, connect the wires as indicated above but DO NOT
connect either wire to the earth terminal.
FMT18-2_Product Instructions 08/09/2014 13:46 Page 4