9
5.
Continue raising the deck sides until you achieve
a deck position of slightly lower in the front than
the back. In this position, when loading the
deck, the platform will lower slightly to a level
position for travel.
NOTE:
You may have to adjust the deck a couple of
times to get the correct position. Never have the
rear deck lower than the front while traveling. If
you cannot achieve a level position, it is better
to have a slightly lower front deck. Once you get
the deck positioned properly for the load, you
will know where to set it each time you haul that
specific item.
6.
You may raise the jack stand legs and pin them
in the up position by utilizing the lower
mounting holes.
7.
If you wish to remove the jack stand legs for
travel - as you are making the deck height
adjustment, raise the deck slightly higher at the
corner and slide the leg out of the stake bed
receiver.
ADJUSTING THE FRICTION
ROTOR ASSEMBLY
ALL SWIVELWHEEL SYSTEMS ARE
SHIPPED WITH A FRICTION ROTOR AND PAD
ASSEMBLY
1.
Adjust the friction pad
(Blue Pad)
so that it
touches the friction plate
(Red Disk)
. Adjust so
that there is slight tension between the friction
plate and friction pad.
2.
Once the correct amount of friction is applied,
tighten the mounting jam nuts to hold the
friction pad in place.
3.
You will notice that some pressure at the rear of
the Swivelwheel system is needed in order to
turn the wheel while moving the system around.
This is normal. When the system is being towed,
the wheel assembly will turn as designed. If you
notice that you cannot move the system around
without really having to push hard, the friction
pad may be too tight.
4.
You may hear a slight squeaking noise when the
wheel turns. This is normal due to the friction
pad turning on the rotor plate.
FLIPPING THE SYSTEM
UPWARD & LOCKING
System Deck
Top
FLIP-UP
FEATURE
MOUNTING
HOLE ONLY
Friction Pad
3
rd
Mounting
Hole
Adjustable
Mounting
Plate
Rotor Plate
Torsion
Suspension
Front Support
Bracket
