Fury RSW55
4
4. Carefully remove the machine from the pallet with the
assistance of others.
Warning! Do not directly drive the
machine off the pallet without using a ramp
. This could
damage your machine.
Install the Batteries
Note:
Please install the batteries after unloading the
machine from the pallet. (See following).
Warning:
Fire or explosion hazard. The batteries release
hydrogen. Please keep away from spark or open flame.
The battery compartment should be kept open when
charging.
For safety: Please wear appropriate protective gear: safety
glasses, apron and gloves when performing battery
maintenance or wiring. Avoid contact with battery acid.
Park the machine on level
ground and switch off main
power (on steering column).
To access the batteries, tip
whole top of machine back.
(Please ensure dust bin
and filter are clean first!)
Place batteries in the
battery compartment and
connect the wiring accord-
ing to the diagram.
Note:
Be sure the poles
are properly connected.
Note:
Place batteries
carefully into the compart-
ment so as to avoid
damaging the batteries or
the machine.
Before connecting the batteries, please ensure whether
the electrodes and terminals are clean. Use terminal
cleaning fluid and wire brush as required.
Paint a thin layer of metal-free lubricating oil or protective
spray on the connected wiring to avoid battery corrosion.
The battery power gauge displays the remaining charge of
the batteries.
If equipped with digital gauge
(0-100%).
To extend the
battery life, it is best to recharge the batteries when the
power gauge is less than 50%. Do not let the batteries run
completely out of charge.
If equipped with lights or digital bar gauge:
When the
battery is fully charged, all indicators are on. As power is
consumed, the indicator lights go out from right to left. To
extend the battery life, it is best to recharge the batteries
as soon as all the indicator lights have gone out.
Battery Charging
Do not keep the batteries in an uncharged state for a long
time. Letting the batteries run completely down may
damage them. The following instructions apply to the
specific charger for this machine. Be sure to use the
proper charger for this machine in order to avoid damaging
the batteries.
Specification of battery charger:
● Type of charger: for lead-acid maintenance free batteries
● Output voltage - 48V
● Output Current - 25A
● Intended for deep cycle batteries
When servicing the machine, wear appropriate safety gear
such as gloves, apron and goggles.
Warning:
Battery acid is highly corrosive. Avoid contact
with battery acid.
1. Move the machine to a well-ventilated area for charging.
2. Park the machine on level ground and turn the key to
the OFF position. Engage parking brake (if equipped).
3. Before charging, check the electrolyte level of each
battery unit (if using non-standard batteries that are not
maintenance free).
4. When charging, open the battery compartment for
ventilation.
5. Insert the AC power cord of the charger into outlet or
other power source.
6. Insert the DC cable of the charger into the battery
charging port at the back of the machine.
7. The charger will automatically begin charging, and will
automatically turn off when batteries are fully charged.
Note:
The machine will not be operable when the charger
is connected. Note: If you must discontinue charging
before the charging is completed, do not unplug the DC
+
+
+
+
+
+
