![background image](http://html1.mh-extra.com/html/fast-and-fluid-management/harbil-ha180/harbil-ha180_operating-and-safety-manual_3535066007.webp)
7
Safety
HA180
V. 2.0
-
Read and strictly comply with the safety data sheets for all colorants, (base) paint and brush liquids.
-
You are responsible for ensuring that Operating Temperature never exceeds the flashpoint of the colorant in
use, or, in the alternative, ensuring that there is no build-up of explosive vapors inside or around the
dispenser.
-
The Operating Temperature consists of the Ambient Temperature in the place of operation, plus an additional
15 °C / 27 °F generated by the dispenser when in use. The Ambient Temperature is determined by factors
such as the temperature in the room or space where the dispenser is being operated, the amount of
ventilation in and around the machine, or any other factors in your operating environment affecting
temperature.
-
In the event Operating Temperature exceeds the flashpoint of the colorant in use, you must take the following
measures:
-
reduce the Operating Temperature by taking steps including but not limited to (a) operating the dispenser
in a room or environment with a lower temperature; (b) increasing ventilation in and around the dispenser;
and/or (c) taking any other steps to reduce the Ambient Temperature; and/or
-
select a different colorant or paint with a flashpoint higher than the likely Operating Temperature.
-
An operational and environmental assessment is required before using flammable colorants in the dispenser,
taking into account all local circumstances including ventilation around the machine, room and machine
operating temperature and room size. Please consult your supplier for more details.
-
The place of operation cannot be an ATEX zone or any kind of explosive atmosphere.
-
In countries for which UL or CSA standards apply: this equipment cannot be used with colorants with a
flashpoint below 38 °C / 100 °F.
2.3
User qualification for installation
Only install the machine when you are a qualified service technician who is trained and certified by Fast & Fluid
Management B.V.
2.4
CE certification
The machine is CE certified. This means that the machine complies with the essential requirements concerning
safety. The directives that have been taken into consideration in the design are available on
www.fast-fluid.com
.
WARNING
The use of flammable colorants or colorants that diffuse potential explosive vapours may present
fire and explosion risks. You are responsible for ensuring there is no build-up of explosive vapours
both inside or around the dispenser.
WARNING
Do not use flammable liquids in the brush container.
WARNING
Risk of fire and personal injury if the temperature inside the dispenser when in use (“Operating
Temperature”) exceeds the flashpoint of the colorant or paint being used.