Faroudja VP301, Инструкция по установке и эксплуатации

Страница: 5 / 19

The Faroudja VP301 Line Multiplier is a precision
video instrument used to convert NTSC interlaced
signals into 600 visible, progressively scanned
lines (800X600 resolution). Using Picture Plusª
technology, the VP301 removes typical video pro-
cessing artifacts while also increasing color purity
and image detail, closely matching 35mm film.
The VP301 is designed as an ideal match for
Graphics-Grade 7Ó and 8Ó CRT projectors that
require a faster processor than the Faroudja Line
Doublers but cannot handle the performance
demands of Line Quadruplers. It is also an ideal
match for three-chip DLP projectors that require
the 800X600 resolution.
Front panel features include Power, Input Select,
Brightness, Contrast, Color, Auto-Tint, Noise
Reduction, Detail, Digital Filter and Freeze. All of
the settings are automatically stored when the unit
is turned off. Also, up to 16 custom presets can be
set. All front panel features can be adjusted by
infrared and RS232 remote control.
Inputs include: Composite Video, S-Video, RGB
and Component. The Video input may be connect-
ed by either a BNC connection or a video RCA
type connection. These inputs are looped internal-
ly so that other devices may use the signal. A
selectable
75-Ohm terminator switch is provided and should
be in the ON position if the input loop is not used.
The S-Video input uses a standard 4-pin connec-
tor. This input is not available for a looped opera-
tion and is terminated internally. The RGB and
Component inputs use BNC connectors. As with
the video input, these inputs can be looped to
other devices. Selectable 75-Ohm terminations are
provided. If the looped inputs are used, these
cables should be kept short (under 6' in length) or
a video distribution amplifier should be used. This
allows the VP301 to keep the highest signal band-
width possible without having the high frequencies
being attenuated in a long cable.
Output from the VP301 is provided by six BNC
connectors as well as one 15 pin ÔDÕ connector.
The BNC outputs provided are Red, Green, Blue,
Horizontal Sync, Vertical Sync and Composite
Sync. Interface to monitors/projectors can be a 4
or 5 wire connection. The VP301 is capable of dri-
ving a monitor/projector using the BNC outputs as
well as a 15 pin ÔDÕ connector, at the same time.
The monitor and projector must be compatible with
a 40KHz Horizontal scan rate.
4
SYSTEM DESCRIPTION