The OSD consists of four menu tabs:
Input – Picture – Display – Patterns
Input Menu
Formats
Input Select: OSD
Video-S-Video- RGB-YCrCb
Note:
The Pass-Thru input cannot be selected from
the OSD since an OSD is not available on that input.
Use the Input button on the remote to select it.
Input Select: Input Button
Video-S-Video- RGB-YCrCb-
PassThrough-PassThruTranscoded
Aspect Ratio*
4:3-Letterbox-Anamorphic
Note:
This selection should match the aspect ratio of
the
source
, not the display. The aspect ratio of the
display should be selected in the Setup menu.
Presets-
Recall:
Factory-1-2-3-4
Store:
1-2-3-4
To store a preset
(in the Input Menu):
•
Press
Menu
button on the remote
•
Make all required adjustments.
•
Use the
Function
keys to select
Store 1 2 3 4.
•
Use the
Value
keys to select the desired preset
number.
•
Press
Enter
To recall a Preset
(in the Input menu):
•
Press
Menu
button on the remote
•
Use the
Function
key to select Recall
•
Use the
Value
key to select a preset
•
Press
Enter
Note:
When using a 4:3 source on a Wide Angle
screen there are black bars on the left and right of the
image. The sidebars can be changed to gray using
the Blanking Level control located in the Display
menu. If filling the entire screen is desired, select
Letterbox. The image will fill the screen but the top
and bottom 1/3 of the image will be cut off
(overscanned).
When watching 2:35 aspect ratio movies on a 16:9
(1:77) screen, it is normal to see black bars at the top
and bottom of the image.
Note:
The screen shape used in the installation
must be set in the Setup Menu during installation for
proper Aspect Ratio mapping. Anamorphic Aspect
Ratio with 4:3 screens and the Wide-4:3 settings are
not available on units with scan rates 480p, 540p,
600p and Frame Doubling. See Setup section
for details.
Note: Do not leave the 4:3 image with a Wide
Angle screen on for long periods of time on a
CRT projector or plasma display. This can
cause permanent image burn-in. Image
burn-in is not covered by Faroudja’s warranty
Picture Menu
Use these commands to fine-tune the image.
Brightness
Factory 50
7
OSD / OPERATING INSTRUCTIONS
INPUT
PICTURE
DISPLAY
PATTERNS
FORMATS
INPUTS
DVD
ASPECT
ANAMORPHIC
PRESETS
RECALL
F 1 2 3 4
STORE
1 2 3 4
INPUT
PICTURE
DISPLAY
PATTERNS
BRIGHTNESS
50
CONTRAST
50
COLOR
50
TINT
50
DETAIL
8
ADVANCED COLOR SYS
NORMAL
